ASP Portable BCR Informations techniques télécharger pdf (Page 12)

Z4 DataTraq

Configuration Functions

Listed on the facing page is a table of the Function codes that can be

used to configure your Z4 DataTraq. These functions are selected by

pressing the FUNC key, followed by the indicated 2 digit number.

Configuration settings made using these functions are stored in the

Z4 DataTraq's battery-backed memory, and remain in effect even if the

power is turned off.

As delivered, the Z4 DataTraq may not be set up correctly for your

computer or software, so you should check the suitability of settings

when you first receive your unit, and configure it as required.

The most commonly used functions are:

Func 10 This function displays the amount of storage memory used

and the amount still available.

Func 11 Downloads the stored data to your computer.

Func 19 After you’ve downloaded the data to your computer, you’ll

need to use this function to clear the storage memory.

Func 05 If you’re having trouble transferring the data to your

computer, you may need to slow down the download using

this function. We’ve set defaults that work for most setups,

but if some of the characters and/or barcodes are being lost,

try doubling the numbers for the Char delay, CR delay

and/or Keybd delay.

Func 00 Displays the firmware version number and date, and the

amount of memory fitted to the unit.

Func 01 This function sets the allowable barcode types. You’ll get

the best results by only turning on those barcode

symbologies that you need, and turning off all other types.

Func 02 You might need to use this function when you first receive

your Z4 DataTraq, to set the type of interface that you want

to use – most commonly IBM AT or RS-232.

Func 04 If you need to scan SCIS (also called ISBN) barcodes, you

can turn that ability on by answering Yes to the “Convert

978 EAN-13 to ISBN” prompt.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 21 22

Pas de commentaire

ASP Portable BCR Informations techniques Page 12